Close-up of a dryer duct connector packed with thick grey lint.

Dryer vent cleaning in Jupiter, FL

Two cycles to dry one load.

We clear the whole exhaust line: the connector behind the drum, every elbow, and the cap outside.

  • A load that needs two cycles to dry
  • A dryer hot to the touch at the end
  • A laundry room that turns humid
  • Lint appearing around the outside vent

4.9 on Google across 57 reviewsAs of See all reviews on Google

Mon-Thu 7 AM-8 PM · Fri 7 AM-5 PM · Sat closed · Sun 7 AM-7 PM · Book online 24/7

  • Florida licensed

    AC contractor CAC1822067

  • Business hours

    Mon-Thu 7 AM-8 PM · Fri 7 AM-5 PM · Sat closed · Sun 7 AM-7 PM · Book online 24/7

  • Same or next day

    Scheduling that fits your week

  • 4.9 · 57 Google reviewsAs of See all reviews on Google

Why the line matters

What changes once the exhaust line is clear.

A dryer is a fan pushing warm, wet air down a duct. Everything below follows from one question: can that air leave the house, or not?

  • Drying time comes back

    A loaded line makes the dryer run a second cycle to finish one load. It is the complaint we hear most on the phone, and it is the first thing that changes.

  • Less lint where the heat is

    Lint is highly flammable, and lint sitting in a hot exhaust line is one of the most common causes of laundry-room fires. Clearing it takes the fuel out.

  • A laundry room that stays dry

    Warm, damp air that cannot leave through the duct leaves through the joints instead. That is why the room turns humid and warm while the dryer runs.

  • The dryer works less hard

    A machine that has to run twice does twice the work for the same laundry. Restoring the airflow is the cheapest thing anyone can do for how long it lasts.

  • A flapper that still seals

    The cap outside has to open with the air and close when the dryer stops. One held open by lint is an invitation to whatever wants to nest in a warm duct.

  • The lint leaves the house

    The line is held under vacuum while the brush runs, so what comes loose travels into our equipment rather than onto the laundry floor or back into the room.

The visit, step by step

Five steps, from the drum to the cap.

Tap any step to see what happens in the laundry room on the day. The dryer line is its own run: it shares nothing with the air-conditioning ducts except the house.

  1. The dryer comes outWe start at the connector, not at the wall.
  2. The line goes under vacuumSo the lint leaves the house, not the room.
  3. A rotary brush runs the full lengthEvery elbow, and the whole rise.
  4. The cap outside is clearedIncluding a termination on the roof.
  5. The flapper is checked, the floor sweptIt has to open, and it has to close.

Step 1 of 5

The dryer comes out

The appliance is pulled forward and the connector behind the drum comes off. That first section is the one that crushes when a dryer is pushed back into place, and it is where the first plug of lint usually sits.

Step 2 of 5

The line goes under vacuum

Before any brush turns, the duct is put under negative pressure at the appliance end, so everything the brush releases travels into our equipment instead of into the laundry room. One review on the profile describes exactly that: no lint escaping into the living rooms.

Step 3 of 5

A rotary brush runs the full length

Lint does not settle evenly. It packs where the duct turns and where it climbs, because that is where the air slows down. The brush travels the full run rather than the first foot a shop vacuum at the wall can reach, and that far length is the part that decides how the dryer behaves.

Step 4 of 5

The cap outside is cleared

The termination is opened and cleared from outside. Several reviews on this profile describe a roof cap completely stuffed with lint, cleared from the roof rather than only from the wall. A vertical run is the hardest part of any dryer line, because gravity works against the exhaust the whole way up.

Step 5 of 5

The flapper is checked, the floor swept

The flapper has to open with the air and seal when the dryer stops, or the duct becomes somewhere to nest. It is checked with the dryer running and again with it off. Then the appliance goes back, the connection is re-made, and the laundry floor is swept before we leave.

Where we clear dryer lines

Jupiter, and thirteen towns around it.

Where the dryer sits decides the job: a ground-floor laundry venting through a side wall is not the same visit as a run that climbs to a cap on the roof. Each town has its own page.

See all service areas
Palm Beach County, with the towns we serve picked out. Stuart is served too and sits in Martin County, just off this map.

Palm Beach County, with the towns we serve picked out. Stuart is served too and sits in Martin County, just off this map.

Green: we serve it

Coverage check

Is your town on the list?

Housing counts are American Community Survey 2024 five-year estimates.

On the Google profile

What people wrote about their dryer line.

4.957 Google reviewsAs of See all reviews on Google

A selection of our 5-star reviews on Google.

  • Brian E.

    Roof-mounted vent cap was completely stuffed with lint; huge relief having them handle the dry vent clean up there.

  • Alexis R.

    They were able to cleanly repair the issue after only a few minutes after finding an unusual whistling sound.

  • Alex I.

    glad I booked with these guys. Really good experience.

Before you call

The questions we get on the phone.

Still not sure which one you need? Call (561) 652-5107 and a technician will talk it through.

Ask us directly
How do I know the dryer vent needs cleaning?
The usual signs are a load that needs two cycles to dry, a dryer that is hot to the touch at the end of a cycle, a laundry room that gets humid while it runs, or lint appearing around the outside vent. Any one of them means the exhaust is not leaving the house the way it should.
How long does a dryer vent cleaning take?
The dryer line on its own is usually under an hour: the dryer comes out, the connector and the full run are brushed and vacuumed, the termination is cleared and the flapper checked, and the appliance goes back. A roof termination, or a long run with several turns, takes longer, and we say so before we start rather than after.
Can you reach a termination on the roof?
Yes, and it is a common job here. Reviews on this profile describe exactly that: a roof-mounted cap completely stuffed with lint, cleared from the roof rather than only from the wall. A vertical run is where lint packs hardest, because the exhaust has to climb the whole way.
Will you move the dryer?
We disconnect and move the dryer to reach the connector behind it, clear the line, then reconnect it and put it back where it was. The laundry floor is swept before we leave, which is something customers have mentioned in their reviews.
How often should a dryer vent be cleaned?
It depends on the run. A short side-wall vent in a two-person household loads up far more slowly than a long run to a roof cap in a house doing laundry every day, so a fixed interval would be a guess. Watch the drying time instead: when a normal load starts needing a second cycle, the line has loaded up again.
Is this the same visit as the air ducts?
It can be, and many visits cover both. The dryer line is a separate run and shares nothing with the air-conditioning ducts except the house, so tell us on the phone which one you want looked at and we will plan the time for it.
What does it cost?
It depends on the length of the run, where it terminates and how loaded it is, so the price is quoted on site, before anything is touched. Nothing is started until you have heard the figure and agreed to it.

Book a visit

Tell us where the house is and what it needs.

We call you back to agree a time inside office hours. Nothing is booked until we have spoken, and the quote comes on site, before any work starts.

Rather talk it through?

(561) 652-5107

Mon-Thu 7 AM-8 PM · Fri 7 AM-5 PM · Sat closed · Sun 7 AM-7 PM · Book online 24/7

We work in Florida only.

A musty smell, a room that never cools, a dryer that needs two cycles, a pet, a gate code.

Helps us bring the right tools. Up to 8 MB each.

Adding photos needs JavaScript. Send the form without them and we will ask for photos by text.

Optional: how we'd use your number:

Seen only by the people who schedule and do the work, except as described in our Privacy Policy.

Book the visit

Tell us how long a load takes to dry.

That one answer tells us most of what we need to know before we arrive, and so does whether the vent comes out through a wall or through the roof.

Book my visit